- Thick rubber pull down stem (glass bowl)
- Transparent rubber tube (cut 3-4 inches)
- Pop top bottle (dispensary container)
- A knife or sharp object
- Water
- Lighter
Poke Holes
Carefully make two airtight holes in the top lid of the dispensary container no wider than the diameter of the glass bowl stem and rubber tube.
Insert
Once the holes have been made, carefully insert the glass bowl so that the stem touches the bottom of the container and the rubber mouthpiece is only barely inserted into the container. (to allow for proper bubbling)
Pour Water
After the glass bowl and rubber tube have been inserted in the dispensary container, carefully pour water into the dispensary container, no higher than 2-3 inches.
Add Medication
Close the lid of the container and put a small amount of finely ground medication into the glass bowl.
Let Er’ Rip!
Again, make sure that the rubber mouthpiece is only slightly inserted into the top of the container, but allow the bowl’s stem to touch the bottom of the container. Slowly light the bowl of medication while carefully inhaling and enjoy!